水性环氧地坪漆对施工环境有哪些要求呢？

在民众环保意识日渐增强的今日，水性环保化已成为涂料行业的发展方向，但相对油性地坪漆，水性环氧地坪漆对施工技能及施工环境的要求较高，不然难以保证地坪工程质量。那水性环氧地坪漆对施工环境有哪些要求呢？一、 环氧地坪施工底漆前需将地上水泥砂浆剔凿并打扫洁净，地上如有油脂类杂质，使用溶剂擦洗洁净防止附着不良；原水泥地上要求坚固、平坦、不起砂，地上如有空鼓、脱皮、起砂、裂痕等，有必要按要求处理后方可施工；

Today, with the increasing awareness of environmental protection, water-based environmental protection has become the development direction of the paint industry, but compared with oil-based floor paint, water-based epoxy floor paint has higher requirements on construction skills and construction environment, otherwise it is difficult to guarantee the quality of floor engineering. What are the requirements for the construction environment of the waterborne floor paint? 1. Before the construction of epoxy floor primer, the cement mortar on the ground should be chiseled and cleaned clean. If there are grease impurities on the ground, the solvent should be used to scrub and clean the ground to prevent bad adhesion. The original cement ground should be firm, flat and sand-free. If there are empty drums, peeling, sand-lifting and cracks on the ground, it is necessary to deal with them before construction. ;

二、如果为水磨石、地板砖等润滑地上，须先打磨成 糙面；

2. If the floor is lubricated with terrazzo and floor tiles, it must be ground to a rough surface first.

三、环氧地坪漆基面应平坦，无积水或无显着渗漏现象；

3. Epoxy floor paint should be flat, without water accumulation or significant leakage.

四、环氧地坪施工时现场相对湿度应低于65%，防止粉尘吹入污染加工区.基面含水率有必要小于8%，并无显着“返潮”现象。

4. Relative humidity should be less than 65% when epoxy flooring is constructed. It is necessary to prevent dust from blowing into the polluted processing area. The moisture content of the base surface should be less than 8%. There is no significant "moisture regain" phenomenon.

五、为了防止环氧地坪施工边际部分沾污及加工处坚持彻底直线或与不涂部分的界限应贴好护面胶带。

Fifth, in order to prevent contamination of the marginal part of the epoxy floor construction and to insist on a complete straight line in the processing section or the boundary between the non-coated part and the epoxy floor construction, the protective tape should be affixed.

六、环境温度在12℃以上，防止固化程度过低，使涂膜性能下降。禁止穿插施工、无关人员进入施工现场。搬运到施工现场的资料，必须放在能够防止风、雨及阳光直射的当地。并做好防火彻底办法。

6. The ambient temperature is above 12 C to prevent the curing degree from being too low and the performance of the film will decrease. It is forbidden to enter the construction site by interposition construction and unrelated personnel. The information transported to the construction site must be placed in a place that can prevent direct wind, rain and sunlight. And complete fire prevention measures.